Installation Instructions
Table Of Contents
- Approvals
- System Overview
- Network Design and Survey
- Installation
- Pre-requisites
- Installing the Hub
- Repeaters
- PPP Modem
- The Browser Interface
- Accessing the HUB with the browser interface
- Connect the Hub to the PC using Windows XP
- Using the Web Browser to Access the EkoTek Hub
- Main menus
- Maintenance Menus
- Configuration menus
- Final Checks
- Appendices
- Related Documentation and Revision History
EkoTek System Installation and Configuration Manual Browser Interface
Maintenance Menus
Device Status
Device Status
Each device in the mesh connects to the Hub via a parent device (repeater or directly to
the hub itself). Maintaining this connection is important. These stats relate to that
connection. Status reports are made every 4 hours.
Device Status Hub
Hub: Serial Number.
Name: Name given to device.
Hardware-Software: Revision number.
Last Report: Time and date stamp.
Battery Level: For Hub will always be 100.
Upstream Link: The name of the parent device to which the local device is connected by
the radio mesh (reported on the Hub as ‘Direct connection’).
Beacon loss count = this records beacons lost during start up/reset.
Parent sync loss = number of times that a loss of sync has occurred.
Link quality = general quality of link to parent, Scale 1 to 100 where 100=best.
Link strength = RSSI of parent link, Scale 1 to 100 where 100=best.
Upstream traffic = count of packets sent to parent.
9261-8173 Issue 2
Page 29
© 2007 Multitone Electronics PLC