Installation Instructions
Table Of Contents
- Approvals
- System Overview
- Network Design and Survey
- Installation
- Pre-requisites
- Installing the Hub
- Repeaters
- PPP Modem
- The Browser Interface
- Accessing the HUB with the browser interface
- Connect the Hub to the PC using Windows XP
- Using the Web Browser to Access the EkoTek Hub
- Main menus
- Maintenance Menus
- Configuration menus
- Final Checks
- Appendices
- Related Documentation and Revision History
EkoTek System Installation and Configuration Manual Browser Interface
11. The default shipped configuration for the Hub is: -
IP address: 192.168.1.2 (1.1.1.1 if via PPP serial port)
Subnet mask: 255.255.0.0
Default gateway: 192.168.1.20
In order to communicate between the PC and the Hub, the IP address of the PC has
to be set to the same Network and Subnet as the Hub. To achieve this select ‘Use
the following IP address’ and enter the IP address in the same range as the Hub (in
the example above 192.168.1.100 and a subnet mask of 255.255.0.0 Gateway
192.188.1.20).
12. Click OK to finish.
Using the Web Browser to Access the EkoTek Hub
In the address field of the web browser, type the IP address of the Hub (default is
192.168.1.2 for ethernet) and click the refresh button. The browser then connects to the
Hub web interface.
9261-8173 Issue 2
Page 25
© 2007 Multitone Electronics PLC