Installation Instructions
Table Of Contents
- Approvals
- System Overview
- Network Design and Survey
- Installation
- Pre-requisites
- Installing the Hub
- Repeaters
- PPP Modem
- The Browser Interface
- Accessing the HUB with the browser interface
- Connect the Hub to the PC using Windows XP
- Using the Web Browser to Access the EkoTek Hub
- Main menus
- Maintenance Menus
- Configuration menus
- Final Checks
- Appendices
- Related Documentation and Revision History
EkoTek System Installation and Configuration Manual Installation
If no 'AT' or 'OK' appears, then there is a basic communication issue between the PC
and the modem - most likely the COMPORT selected is incorrect - check this and try
again.
If problems persist:
• Check Windows Device Manager (where available):
• Check that the Modem is installed.
• Check the COM Port is enabled and has no clashes (indicated by a yellow
exclamation mark next to it).
• Check the COMPORT is enabled in the system BIOS setup.
6. To store the configuration of the port speed in the modem, type 'AD&B2&W' and
press 'Enter'. You should receive an 'OK' as a response.
7. Remove the lead from the PC COM port and connect to the PPP socket on the Hub.
8. Close the cover on the Hub. Ensure that the ribbon for the keypad is connected to the
header on the daughter board, as this is sometimes dislodged when the cover is
removed.
9. Test by dialling in to the modem from a PC. The User name and Passwords are both
‘EkoTek’. The modem should auto answer and the EkoTek menu screen should be
displayed.
10. Set up system configuration using the browser as described in the next section
9261-8173 Issue 2
Page 22
© 2007 Multitone Electronics PLC