Installation Instructions
Table Of Contents
- Approvals
- System Overview
- Network Design and Survey
- Installation
- Pre-requisites
- Installing the Hub
- Repeaters
- PPP Modem
- The Browser Interface
- Accessing the HUB with the browser interface
- Connect the Hub to the PC using Windows XP
- Using the Web Browser to Access the EkoTek Hub
- Main menus
- Maintenance Menus
- Configuration menus
- Final Checks
- Appendices
- Related Documentation and Revision History
EkoTek System Installation and Configuration Manual Installation
2. Load HyperTerminal:
• Click Start > Run
• In the box which appears, type in: HYPERTRM
• Click OK.
If you see the error message 'Cannot find HYPERTRM' you will need to install
HyperTerminal:
• Click Start > Settings > Control Panel > Add / Remove Programs.
• In Add / Remove Programs select Properties and then click the Windows Setup tab.
• Double-click Communications
• Check the box for HyperTerminal
• Click OK, and then OK again to install.
• Note: You may be asked for your Windows installation disk for this procedure.
3. When HyperTerminal starts you will be presented with a 'Connection Description'
dialogue box.
• Click 'Cancel' to continue.
4. Select your COM Port:
• Select 'File' then 'Properties' from the menu bar and the 'New Connection
Properties' window will open.
• Click on the arrow for the 'Connect Using' drop down box.
9261-8173 Issue 2
Page 19
© 2007 Multitone Electronics PLC