Installation Instructions
Table Of Contents
- Approvals
- System Overview
- Network Design and Survey
- Installation
- Pre-requisites
- Installing the Hub
- Repeaters
- PPP Modem
- The Browser Interface
- Accessing the HUB with the browser interface
- Connect the Hub to the PC using Windows XP
- Using the Web Browser to Access the EkoTek Hub
- Main menus
- Maintenance Menus
- Configuration menus
- Final Checks
- Appendices
- Related Documentation and Revision History
EkoTek System Installation and Configuration Manual Installation
Figure 10. Repeater Back Plate
If fixing to masonry, drill two holes with a 5mm masonry bit to a depth of 25mm and insert
wall plugs.
Screw the back plate in position using a PH1 Pozidrive bit.
Ensure the batteries are in place and slide the Repeater into position.
Lock the Repeater (if required) by screwing the small screw provided in the installation
parts, as indicated by A in the photo above
PPP Modem
PPP connection to the Hub is made using a US robotics 5630D modem.
1. Plug the modem into the serial port of a PC using the serial interface cable provided
with the modem. Use an adapter if the PC does not have a serial port. See
Appendix 3 (page 51) for details of cable pinouts.
2. Install the US Robotics software onto the PC, from the CD provided with the modem.
3. After installation, locate the software in the programs menu on the PC and start.
The software automatically detects if the modem is connected.
9261-8173 Issue 2
Page 17
© 2007 Multitone Electronics PLC