Installation Instructions

Table Of Contents
EkoTek System Installation and Configuration Manual Installation
Interface Connections
DC
Ethernet
(RJ45)
Alarm Output
TAP
(DB9)
PPP
(DB9)
Figure 8. Interface Connections
Plug in the AC to DC power adapter
Plug in the Ethernet patch lead to connect to the LAN or PC. See also Connect the Hub to
the PC using Windows XP (page 23).
If an external alarm is to be activated from the Hub, connect a pair of wires from the alarm
output shown in Figure 8. Interface Connections. The alarm output is a simple make
contact and can be used to operate a customer provided alarm relay. This is not designed
to provide a direct contact for AC mains operated equipment.
Connect the DB9 TAP connection to the customer's paging system if required. The
connection cable should be as specified by the paging system.
The PPP connection is made after the modem has been set-up. See
PPP Modem (page 17) for further details.
Repeaters
Figure 9. Repeater
Mounting the Repeater
Remove the back plate from the Repeater by sliding it in the direction shown.
Use the back plate to mark the position of the screw holes on the wall or ceiling.
9261-8173 Issue 2
Page 16
© 2007 Multitone Electronics PLC