Installation Instructions
Table Of Contents
- Approvals
- System Overview
- Network Design and Survey
- Installation
- Pre-requisites
- Installing the Hub
- Repeaters
- PPP Modem
- The Browser Interface
- Accessing the HUB with the browser interface
- Connect the Hub to the PC using Windows XP
- Using the Web Browser to Access the EkoTek Hub
- Main menus
- Maintenance Menus
- Configuration menus
- Final Checks
- Appendices
- Related Documentation and Revision History
EkoTek System Installation and Configuration Manual Installation
Installing the Hub
Figure 6. Hub
The Hub can be freestanding on a desk, or wall mounted using the screws provided.
To remove the cover, depress the two protruding plastic tabs and separate the top from
the back plate.
Wall Mounting
Mark the position of the screws on the wall. The two screws should be spaced precisely
120mm apart.
Figure 7. Hub Back Plate
Drill two holes with a 5mm masonry bit to a depth of 25mm.
Insert the wall plugs and screw the screws in using a PH1 Pozidrive bit. Leave 7mm of the
screw protruding.
Locate the screw heads in the holes in the back-plate and pull the unit down to lock into
place.
9261-8173 Issue 2
Page 15
© 2007 Multitone Electronics PLC