Specifications

3
1.1 General
PowerSig M560 multifunction transducer is a complete
measuring system in a single 100mm Din rail mount case.
Measuring Phase Volts, Phase Current, Frequency, Active
Power, Reactive Power, Energy and Demand. The M560
provides up to 3 analogue outputs and the options of
RS485 modbus output and pulsed output.
Power Systems :-
Product code
1 Ph. M560-AT1
1 Ph. 3 Wire M560-AT1-3
3 Ph. 3W unbalanced load M560-AT4
3 Ph. 4W unbalanced load M560-AT9
Phase Voltage (V), Phase Current (I), Frequency (Hz),
Active Power per phase (W), System Active Power (W),
Reactive Power per phase (VAr), System Reactive Power
(VAr), Apparent Power per phase (VA), System Apparent
Power (VA), Import Active Energy (W.h), Export Active
Energy (W.h), Import Reactive Energy (VAr.h),
The M560 units are fully programmed by the factory and
no further programming is necessary. If the RS485 option is
ordered, the user can reprogram parameters to individual
requirements, such as the voltage and current ratios, relay
output, demand times as well as assign different param-
eters to the outputs. These programming operations are
covered in this manual.
The M560 uses a high speed microprocessor and analogue
to digital conversion circuitry. Each phase current and
voltage is measured continuously and all other parameters
are derived from these measurements in the software.
Voltage and current measurements are true RMS.
1.2 Parameters Measured
The M560 Measures the following parameters :
M560AT~1.PM5 01/08/101, 12:513