Specifications

ACTION : Click on
Available Outputs Box.
COMMENTS :
Using the up and down
cursor choose parameter
required for analogue
output 2. Example if Watts
in Phase 3 is required select
W3.
ACTION : Click on >>
Button.
COMMENTS :
Output 2 = W3 (this appears
in Node No1 Box)
ACTION : Click on
Available Outputs Box.
COMMENTS :
Using the up and down
cursor choose parameter
required for analogue
output 3. Example if system
frequency is required choose
Hz.
Note : If a parameter is entered into the Node No1 box in
error, Click << button. The parameter is then removed and
the desired parameter can be entered. Click on Clear
Button and all parameters in Node No1 Box are removed.
30
M560AT~1.PM5 01/08/101, 12:5230