User`s guide

ADSL/VoIP Gateway User’s Guide
76
14 Reset to Defaults
This page allows you to reset your device to its default factory
settings.
The configuration settings of your device are stored in a
configuration file. When you set up your device and access the
web pages for the very first time, the configuration file contains
a default factory configuration. This configuration has been set
by Multitek for you, and contains the basic settings that you can
use without having to make extensive changes to the
configuration.
If you do make changes to the default configuration but then
wish to revert back to the original factory configuration, you can
do so by resetting the device to factory defaults.
Resetting to Defaults
Note
If you reset your device to factory defaults, all previous
configuration changes that you have made are overwritten by the
factory default configuration.
1. From the left-hand Setup menu, click on Reset to Defaults.
The following page is displayed:
Figure 91: Reset to Defaults page
2. This page reminds you that resetting to factory defaults
cannot be undone – any changes that you have made to
the basic settings will be replaced. If you are happy with
this, click in the Confirm box to tick it, then click Reset to
Defaults. The following page is displayed:
Figure 92: Resetting to Defaults… page
This page confirms that the device is currently resetting to
factory defaults. Once the reset is complete, the Current
Status page is displayed. See Current Status on page 24.