User`s guide

ADSL/VoIP Gateway User’s Guide
47
If you are following the First Time Settings wizard, the next
page in the wizard sequence is displayed, which allows you
to Configure Wireless Address Authentication.
If you have accessed this page from the General Settings
section of the Wireless Network page, click on the Confirm
Changes button to apply changes and return to the
Wireless Network page.
• If you want to use WEP 64bit data encryption, click on the
64bit encryption on the wireless network radio button and
then click Next>. Now follow the instructions in Configuring
64bit or 128bit encryption on page 47.
• If you want to use WEP 128bit data encryption, click on the
128bit encryption on the wireless network radio button and
then click Next>. Now follow the instructions in Configuring
64bit or 128bit encryption on page 47.
• If you want to use WPA, click on the Wi-Fi Protected
Access (WPA) on the wireless network radio button and
then click Next>. Now follow the instructions in Configuring
WPA security on page 48.
Configuring 64bit or 128bit encryption
The example set in this section is for 128bit encryption, however
the outline also applies to 64bit encryption.
1. Once you have selected your WEP encryption method and
then clicked Next>, the following page is displayed:
Figure 37: Wireless Network: 128bit Network Key page
2. Click in the Key box and type a unique 26-character hex
network key, such as A6F34B2CE5D68BE90A6F34B2CE.
Note
Hexadecimal or ‘hex’ numbers each have a value of 0 to 9 or A to
F. Each number represents four bits of binary data.
Note that if you selected 64bit, you will need to type a
unique 10-character hex network key.
3. Click Next>.
If you are following the First Time Settings wizard, the next page
in the wizard sequence is displayed, which allows you to
Configure Wireless Address Authentication.
If you have accessed this page from the General Settings
section of the Wireless Network page, click on the Confirm
Changes button to apply changes and return to the Wireless
Network page.