User`s guide

ADSL/VoIP Gateway User’s Guide
17
ADSL/Ethernet Bridge/Router
Power
FXS
ADSL
FXO
1
Telephone
Wall
phone
port
AC adapter
Wireless PCs
5
Ethernet Ports
Networked Computers
4
Telephone
FXS
Figure 4: Overview of Hardware Connections
Step 1. Connect the DSL cable and optional telephone line
Connect one end of the provided phone cable to the port
labeled DSL on the rear panel of the device. Connect the other
end to your wall phone port.
Step 2. Connect the Ethernet cable
Connect either a LAN hub or up to four single Ethernet
computers directly to the device via Ethernet cable(s).
Note that the cables do not need to be crossover cables.
Step 3. Attach the power connector
Connect the AC power adapter to the Power connector on the
back of the device and plug the adapter into a wall outlet or
power strip. Turn on and boot up your computer(s) and any LAN
devices such as hubs or switches.
Step 4. Configure your Ethernet PCs
You must also configure the Internet properties on your
Ethernet PCs. See Configuring Ethernet PCs on page 88.
Step 5. Connect Wireless PCs
Only include this step if your product supports the use of
wireless.
Your device provides a wireless network card for a Wireless
LAN connection (see Front Panel LEDs).