Specifications

3.0 PROGRAMMING MODBUS REGISTERS SEQUENCE
If changing of the modbus order is not required please move
to section 4.0 communication.
3.1 Using the M550 Software.
M550 software can be obtained from your Multitek
distributor or from our website www.multitek-ltd.com.
3.2 Load disc and open Mbregs, (This is the Modbus Regis-
ters Tool program) and the screen below will be displayed.
4.3 This software allows the user to alter the sequence in
which the Modbus addresses are read. So for example if the
user was only interested in Watts Hz Power Factor, then
these 3 registers could be set as the first 3 and the
remaining registers ignored.
The following parameters are set by default to the
following readings, all can be changed if required. See
section 2.3 to 2.6. Response time = 300mS, Node = 1,
27
M550MAN.PM5 01/08/101, 12:4827