Owner`s manual

Chapter 2 - Installation

9. Repeat steps 6 through 8 for the remaining modems

(devices).

10. If necessary, refer to the modem (device) Owner's Manual

for connecting the cables and telephone lines to the

modems (devices).

11. When all the modems (devices) are connected to the

computer and the telephone lines, plug the AC power cord

supplied with the rack into the power cord connector on

the back of the rack and to a live AC outlet.

Powering Up

Once power is applied to the rack, the modems perform a

diagnostic self-test, indicated by the speed LEDs flashing in

sequence for approximately two seconds, then the 96, 14, 28,

33, or 56 (depending on the type of device installed) should

light. If none of the modems have power applied to them,

check the power cord connection to the rack, then check that

the AC outlet is live. If one or more modems do not power up,

check the power connections to them.

If one of the green power supply LEDs on the front of the rack

is not on, then one of the redundant power supplies may be

defective (or disconnected from input power).