Owner`s manual

Chapter 2 - Installation

Installation

Perform the following procedure to install the ZDX rack and

install up to 12 modems (devices) in the rack. See Figure 2-1.

1. Unpack the rack and check all items against the shipping

list to ensure that you have received the correct items.

Rack Components

A. Rack

B. Power Cord

C. Owner's Manual

2. Inspect the rack for visible shipping damage. If damage is

observed, do not power-on the rack; contact Multi-Tech's

Technical Support for advice (refer to Chapter 3).

3. If no damage is observed, mount the rack in a standard

19-inch wide rack enclosure. Use standard mounting

hardware supplied with the rack enclosure.

4. Open the front door of the ZDX rack.

5. Unpack the ZDX modems (devices) to be installed in the

rack.

Note: Because of the limited height clearance in the ZDX

rack, do not attach the plastic feet to the devices; also, do

not use the power supply cords supplied with the devices.

6. Ensure that the power on/off swith on each ZDX modem is

set to the On position before sliding the modem (device)

into the rack. (The power on/off switch is not accessible

once the deviceis installed in the rack.)

7. Slide a ZDX modem (or other device) into one of the 12

available slots.