User guide

TalkAnytime User Guide Technical Configuration
99
E1 Parameter Definitions (cont’d)
Field Name Values Description
FXS Ground/Loop Start
Supervision Parameters
Tone Detection
(Enable)
Y/N After a specified tone (chosen
from the Available Tones list)
coming from the PBX is
stopped, the FXS interface will
send the ‘connect’ signal to the
calling party.
Available
Tones (List)
Busy Tone, Dial
Tone, Reorder Tone
Survivability Dial
Tone, Unobtainable
Tone
List from which tones can be
chosen to signal call answer.
Answer Tones
(List)
Busy Tone, Dial
Tone, Reorder Tone
Survivability Dial
Tone, Unobtainable
Tone
Currently chosen call-answer
supervision tone.
ISDN Parameters
Field Name Values Description
Enable
ISDN-PRI
Y/N If digital connection is ISDN-
PRI type, this box should be
checked. When ISDN is
enabled, the “CAS Protocols”
field is grayed out (ISDN has its
own signaling method).
Terminal/
Network
either
“Terminal” or
“Network”
When “Terminal” is selected, it
indicates that the TalkAnytime
should emulate the subscriber
(terminal) side of the digital
connection. When “Network”
is selected, it indicates that the
TalkAnytime should emulate
the central office (network) side
of the digital connection.
Setting used for TalkAnytime must
be opposite to the setting used in
the PBX. For example, if the PBX is
set to “Terminal,” then the
TalkAnytime must be set to
“Network.”