User guide

Technical Configuration TalkAnytime User Guide
92
T1 Parameter Definitions (cont’d)
Field Name Values Description
FXS Ground/Loop Start
Supervision Parameters
Tone Detection
(Enable)
Y/N After a specified tone (chosen from the Available Tones
list) coming from the PBX is stopped, the FXS interface
will send the ‘connect’ signal to the calling party.
Available
Tones (List)
Busy Tone, Dial
Tone, Reorder Tone
Survivability Dial
Tone, Unobtainable
Tone
List from which tones can be chosen to signal call
answer.
Answer Tones
(List)
Busy Tone, Dial
Tone, Reorder Tone
Survivability Dial
Tone, Unobtainable
Tone
Currently chosen call-answer supervision tone.
ISDN Parameters
Field Name Values Description
Enable
ISDN-PRI
Y/N If digital connection is ISDN-PRI type, this box should be
checked. When ISDN is enabled, the “CAS Protocols”
field is grayed out (ISDN has its own signaling method).
Terminal/
Network
either
“Terminal” or
“Network”
When “Terminal” is selected, it indicates that the TalkAnytime
unit should emulate the subscriber (terminal) side of the digital
connection. When “Network” is selected, it indicates that the
TalkAnytime unit should emulate the central office (network)
side of the digital connection.
Setting used for TalkAnytime unit must be opposite to the
setting used in the PBX. For example, if the PBX is set to
“Terminal,” then the TalkAnytime unit must be set to
“Network.”