User guide

Technical Configuration TalkAnytime User Guide

Voice/Fax Parameter Definitions (cont’d) )

Field Name Values Description

Auto Disconnect

Automatic

Disconnect-

ion

-- The Automatic Disconnection group provides four options which

can be used singly or in any combination.

Jitter Value 1-65535

milli-

seconds

The Jitter Value defines the average inter-arrival packet deviation

(in milliseconds) before the call is automatically disconnected. The

default is 300 milliseconds. A higher value means voice

transmission will be more accepting of jitter. A lower value is less

tolerant of jitter.

Inactive by default. When active, default = 300 ms. However, value

must equal or exceed Dynamic Minimum Jitter Value.

Call

Duration

1-65535

seconds

Call Duration defines the maximum length of time (in seconds)

that a call remains connected before the call is automatically

disconnected.

Inactive by default.

When active, default = 180 sec.

This may be too short for most configurations, requiring upward

adjustment.

Consecutive

Packets Lost

1-65535 Consecutive Packets Lost defines the number of consecutive

packets that are lost after which the call is automatically

disconnected.

Inactive by default.

When active, default = 30

Network

Discon-

nection

1 to 65535

seconds;

Default =

30 sec.

Specifies how long to wait before disconnecting the call when IP

network connectivity with the remote site has been lost.