User guide

TalkAnytime Quick Start Instructions Gathering Phone/IP Details
23
Phone/IP Details *Absolutely Needed*
Before Starting the Installation
The TalkAnytime will interface with both the IP network and the phone system. You must gather
information about the IP network and about the phone system so that the TalkAnytime can be configured
to operate with them properly. A summary of this configuration information appears on page 26 (“Config
Info CheckList”).
Gather IP Information

Ask your computer network
administrator.
IP Network Parameters:
Record for this
TalkAnytime unit.
#
• IP Address
Note: The default IP address of TalkAnytime units
is 192.168.3.143.
• IP Mask
• Gateway
• Domain Name Server (DNS) Info (optional)
• Determine whether or not 802.1p Packet Prioritization
will be used.
T1 Telephony Parameters (for TA2410)
The following parameters must be known about the PBX or telco central office equipment to which the T1
TalkAnytime unit will connect:

T1 Phone Parameters
Ask phone company or
PBX maintainer.
Info needed to operate:
TA2410
T1 Parameters:
Record for this
TalkAnytime unit.
#
• Which frame format is used?
ESF___ or D4___
• Which CAS or PRI protocol is used? ______________
• Clocking: Does the PBX or telco switch use
internal or external clocking? _________________
Note that the setting used in the TalkAnytime unit will
be the opposite of the setting used by the telco/PBX.
• Which line coding is used?
AMI___ or B8ZS___
Write down the values for these T1 parameters. You will need to enter these values in the “T1/E1/ISDN
Parameters” screen in the Configuration section of the TalkAnytime software.