User guide

Chapter 6 – RouteFinder Software
Multi-Tech Systems, Inc. RouteFinder RF850/860 User Guide (PN S000400E) 63
Networks & Services > Services
Editing and Deleting User-Added Services
There are options for editing or deleting the user added services. However, there are some standard
services which cannot be edited or deleted. If the service is used by the Packet Filter rules, SNAT, or
DNAT, it cannot be deleted.
For editing any user-defined service, the Edit button has to be clicked to get the fields corresponding
to the service entry.
Edit
By clicking Edit in the Options column, the information is loaded into the entry menu of the Edit
Service screen. You can then edit the entry. You can edit user-added services only. The entries
can be saved using the Save button.
Delete
By clicking Delete in the Options column, the service is deleted from the Services table.
Changes can be saved using the Save button.
Notes About Protocols
1. TCP & UDP allow both protocols to be active at the same time.
2. The ICMP protocol is necessary to test network connections and RouteFinder functionality, as
well as for diagnostic purposes. In the Packet Filter > ICMP menu you can enable ICMP
Forwarding between networks, as well as RouteFinder ICMP reception (e.g., to allow ping
support).
3. The ESP protocol is required for Virtual Private Network (VPN).
4. The AH protocol is required for Virtual Private Network (VPN).
5. For AH and ESP, the SPI is a whole number between 256 and 65536, which has been mutually
agreed upon by the communication partners. Values below 256 are reserved by the Internet
Assigned Numbers Authority (IANA).
Entries on This Screen Display on Other Screens
Service Names added on this screen will display on the following screens
Screen Fields
Packet Filter Rules Add packet filter rules
Packet Filters > Advanced MAC Address Based Filtering
Network Intrusion Detection Add specific services for Network Intrusion Detection
SNAT Add rule
DNAT Add rule