User guide

Chapter 2 – Installation
6 Multi-Tech Systems, Inc. RouteFinder RF850/860 Quick Start Guide (82100051L)
Chapter 2 – Installation
Installation Notes
See the User Guide for sections on Planning Your Network and Establishing an Address Table.
Front Panel
LEDs Description
10MB
WAN1, WAN2/DMZ: Lights when a successful 10Base-T Internet connection is
established.
LAN: Lights when a successful 10Base-T Ethernet connection is
established.
ACT
WAN1, WAN2/DMZ: Lights when the port has a valid Internet connection.
Blinks when it is receiving or transmitting data.
LAN: Lights when the LAN port has a valid Ethernet connection.
Blinks when it is receiving or transmitting data.
100MB
WAN1, WAN2/DMZ: Lights when a successful 100Base-T Internet connection is
established.
LAN: Lights when a successful 100Base-T Ethernet connection is
established.
Disk ACT
Lights when the disk drive is accessed.
Status
When functioning normally, the LED blinks. The LED is a solid light when the RouteFinder
is booting up, saving the configuration, restarting, or updating the firmware.
Power
Lights when power is being supplied to the RouteFinder.