User guide

Chapter 3 – Configuration Using Web Management Software
26 Multi-Tech Systems, Inc. RouteFinder RF850/860 Quick Start Guide (82100051L)
Example 2 –Two RouteFinders Behind a NAT Device – Side B
Step 3 – VPN Setup (Continued)
The Add IKE Connection screen displays. All settings can be left at the default unless otherwise
indicated:
1. Connection Name: Enter the name of the VPN tunnel you want to create. For this example,
enter Behind-NAT.
2. Secret: Enter the Secret password (which has to match on both ends of the tunnel). For this
example, enter test.
3. Select Encryption: Select 3DES.
4. Local WAN IP: Select WAN.
5. Local LAN: Select LAN.
6. Remote Gateway IP: Select RF850-WAN.
7. Remote LAN: Select RF850-LAN.
8. UID: Click the Enable button (must be enabled when using NAT).
9. Local ID: Enter the local security gateway ID (required when using NAT). For this example,
enter 65.126.90.248
10. Remote ID: Enter the remote security gateway ID (required when using NAT). For this example,
enter 192.126.2.8
11. Click the Save button to save your tunnel.
The VPN > IPSec Status screen displays; this time showing the newly-created VPN tunnel.
Important Note:
Make sure to check
the Status box for
this VPN tunnel in
order to activate it.