User guide

Multi-Tech Systems, Inc. RouteFinder RF802EW User Guide
Chapter 5 - Telnet
53
l). Routing Table
The Routing Table option lets you create a routing table so your RouteFinder will route IP
packets to the proper network. For more information, refer to the Routing Table section of
the RouteFinder Manager chapter of this User Guide.
m). Client Filter Settings
The Filter Settings option allows you to define which packets are allowed to either pass
through, or be blocked from passing through the RF802EW ports. You may filter packets
for network services including Mail, WWW, FTP, Telnet and News. See the Filter Settings
section of the RouteFinder Manager chapter for more information about filtering options.
n). Load Default Settings
Use this option to return the router to the factory default settings.
o). Save and Restart Server
This option saves your RouteFinder configuration into Flash memory and restarts the device
to enable the settings to take effect. The system will pause while settings are being saved.
Note: After completing your configuration, you must select Save and Restart Server or
your settings will be lost when power is turned off for the device.
p). Diagnostic
The Diagnostic option performs basic testing of the RouteFinder, displays information about
your firmware and offers options for assigning the LAN and WAN MAC addresses as may be
required by your ISP.
Type any key to return to the main menu.
q). Quit