User guide

Chapter 6 – Managing the RouteFinder Using a Web Browser
Multi-Tech Systems, Inc. RF560VPN User Guide 46
– WAN Filter Settings
To access this screen, click the Filter Settings button on the left side of the Advanced Settings
screen. Then click the WAN Filter Settings button on the left side of the screen. The WAN Filter
Settings screen displays.
The WAN Filter Settings function allows the network administrator to define whether remote/outside
users have the permission to access the local network. To activate, check the WAN Side Filter
Enabled box. Then define the policy.
1. Check the WAN Side Filter Enabled box to begin a list of users and permissions.
2. Select the WAN side filter: Block or Pass.
3. Select the client filter settings: Block or Pass.
4. Select the protocol to be used from the Protocol drop-down list box.
5. Enter the client IP Address Range and Destination Port Range.
6. Click the Add button. The entry displays on the lower part of the screen.
7. Continue adding table entries. When complete, click the Submit button (not shown on this
screen capture).