User guide

RouteFinder RF500S Quick Start Guide
4
Cabling Directions
Before beginning, turn the power off on all network devices (PCs, Cable/DSL
modems, analog modems, ISDN TAs, and the router).
1. Connect the Ethernet port of each PC or network device to one of the 4
LAN ports.
Important: If you are using the Uplink option, Port Number 1 cannot
be used as a LAN port).
2. If you are using an analog modem, connect it to the Serial Async port.
3. If you are using the Uplink option to connect to another network
segment, slide the Uplink/Normal switch into the Uplink position.
Connect the LAN cable to LAN Port Number 1. Plug the other end of
the LAN cable into another hub, router, or switch.
Note: If you are not using the Uplink feature, place the switch in the
Normal position.
4. Connect a network cable from the cable or DSL modem to the 10 BT
WAN port.
5. Connect the provided power supply cable to the 5VDC power port on
the back of the router. Plug the power supply into an AC power outlet
as shown above.
Power and Reset Button
1. Power on your cable or DSL modem.
2. If you are using an analog modem or ISDN TA, power on the device.
3. Press and hold the RouteFinder’s Reset button for 3 seconds to restore
the default settings.