User guide

Configure and Manage Using a Web Browser

– Administrative Settings

Use this screen to change your RF500S password, set the HTTP port

number, set remote user configuration, and establish system log settings.

1. To access this screen, click the Administrative Settings button on the

left side of the Advanced Settings screen.

2. Password: To set a new password, type the new one in the New

Password

box and re-type it for verification in the Retype Password

box. If you do not want to change any other item on this screen, click

the Submit button to accept the password change.

Important: It is important to remember your password. If for any reason

you lose or forget it, press the small reset button on the back of the RF500S.

Hold the reset button until the serial LEDs of the RF500S blink, and then

release the reset button. This reset action will re-initialize the settings.

However, all configurations, including the password, will be reset. You will

have to reconfigure all of your RF500S settings.

3. System Administration: The settings in this portion of the screen can be

used to give a remote user(s) the ability to configure and administrate

the RF500S through the Internet. The default IP address of the remote

administration host is 0.0.0.0. This address means that any remote user

can access and manage the RF500S.

HTTP Port Number: The default value is 80.

Allow Remote User to Configure the Device Check Box: To give remote

users the ability to configure and administrate the RF500S, you have to

check this box.

IP Address: Type the RF500S WAN IP address into the browser of any or a

specific PC on the network.

http://192.168.100.1:1023

http://<WAN IP Address>: <Port Number>

Important: Once the HTTP port number (NOT Port 80) is changed and the

users of the LAN terminal want to configure the RF500S, the users have to

type the LAN IP address with the port number: 192.168.2.3.:1023

4. If you want to allow a remote user to PING the device, check the

corresponding box. See information about PING in the Appendix in the

complete User Guide.

5. If you want to enable the system log function, check the corresponding

box, and enter the

Log Server IP Address.

6. If you want enable a

Detail Debug IPSec Log, check the corresponding

box.