User guide

32
Chapter 5 - RouteFinder Manager
General Settings
After selecting your device from the Available Devices list, click General Settings to view or change
all of the major network settings for the RF102S including LAN Ethernet Segment, IP Routing, and
Remote Access settings. Most of these settings were entered in Setup Wizard. However, some
important settings can be entered only in RouteFinder Manager.
LAN Ethernet Segment
Server IP address
This IP address is the internal LAN IP address of the RF102S. The address entered into the
Setup Wizard is displayed here (for example, 192.168.2.1).
Server IP Netmask
The RF102S subnet mask generally can be left at the default value of 255.255.255.0.
Port Function
The Serial ports can be configured to provide either IP Routing or Remote Access. IP Routing is
used to connect your network to another router through one or both of the Serial ports. Remote
Access enables remote users to dial-in to the device to access and share network resources as if
they were logged on to the network locally.
1. To configure the RF102S for IP Routing, click IP Routing in the Async Port section of the
General Settings dialog box.
2. Click PPP Settings.