User guide

29
Chapter 4 - Telnet
Routing Table
The Routing Table option lets you create a routing table so your RouteFinder will route IP packets to
the proper network. For more information, refer to the Routing Table section of the RouteFinder
Manager chapter of this User Guide.
Client Filter Settings
The Filter Settings option allows you to define which packets are allowed to either pass through, or
be blocked from passing through the RF102S ports. You can filter packets for network services
including Mail, WWW, FTP, Telnet, and News functions. See the Filter Settings section of the
RouteFinder Manager chapter for more information about filtering options.
Load Default Settings
Use this option to return the router to the factory default settings.
Save and Restart Server
This option saves your RouteFinder configuration into Flash memory and restarts the device to
enable the settings to take effect. The system will pause while saving the settings.
Note: After completing your configuration, you must select Save and Restart Server or your settings
will be lost when power for the device is turned off.
Debug Mode
The Debug Mode shows the current status the protocols running on your RouteFinder. It can also be
used to ping IP addresses, to display the hardware interface and routing table, and set wireless
parameters.