User guide

Chapter 4 - Telnet

Serial Baudrate

Use the list to select the appropriate baudrate of the modem attached to your async port. You may

need to select a lower speed to ensure a quality connection.

Modem Pre-Initial string

Consult your modem or ISDN TA User Guide for this information. The default value will work for most

analog modems.

Modem Initial string

Consult your modem or ISDN TA User Guide for this information.

Modem dialup string

Consult your modem or ISDN TA User Guide for this information.

Modem hangup string

Consult your modem or ISDN TA User Guide for this information.

Select Enable or Disable.

Edit login script

Refer to Chapter 5 for information on editing scripts.

External IP address

Enter the IP address of the remote device to which you are connecting.

NAT Function

Select Enable or Disable. Refer to the Glossary for additional information on NAT.

Assign Remote IP

Select Enable or Disable. If you select Enable, you will be prompted to enter an address to be

assigned to the remote system.

Remote Access

To configure the async port for Remote Access, enter information for each of the following:

Remote Access Port Settings

IP Assigned Method

Select the method the client will use to have their IP address assigned.

Protocols

Default value is Both IP and IPX enabled. You may select to use only one protocol, however if you

are connecting to a Netware server, you must have IPX enabled.

IPX/SPX Frame Type

The default value is Autodetect. If you have problems with your network connection, you may select

Ethernet_II, Ethernet_802.3, Ethernet 802.2 or Ethernet_snap.

Authentication Method

Select either None, PAP or CHAP. Refer to the RouteFinder Manager chapter of this User Guide for

additional information.