User guide

26
Chapter 4 - Telnet
Router IP Address
Enter the IP address assigned to the RF102S on your local network. The new address will take
effect after you have selected Save and Restart Server.
Router Subnet Mask
Enter the subnet mask for your local network.
Router Name
Enter a network name for the RF102S. If your ISP requires your device to have a name, you can use
the one entered here.
Router Password
The default is no password. If you choose to use a password, ensure that you write the password
down and keep it in a safe place. If you forget the password, contact the Multi-Tech System’s
Technical Support group for assistance. Refer to Chapter 10 in this User Guide for contact
information.
Router MAC address
Displays the current MAC address of your router. Edit this only if required by your remote system or
ISP.
Async Port 1 and 2 Settings
The async ports can be used for IP Routing or Remote access. For more information, see the
General Settings section of Chapter 5.
IP Routing
If you will use the async port for IP Routing, enter the following information as described:
Telephone number
Enter the phone number the async device must dial to connect to the remote system.
User Name
Enter the User Name that will be used for authentication on the remote system.
Password
Enter the Password associated with the User Name for the remote system.
Idle Timeout
Enter the amount of idle time allowed to pass before the connection times out. The default value is 5
minutes.