User guide

22
Chapter 3 - Software Installation and Configuration
12. The Modem Initial Command dialog box displays.
Select your modem manufacturer and model and click OK.
Note: This setting configures the initial string of the asynchronous port on the RF102S so that it
will know how to communicate with your modem. If you are using an analog modem and your
modem is not included in the selection list, in most cases, Standard Modem will work. If you are
using an ISDN TA, refer to the ISDN TA’s User Guide for information on the initialization and hang
up strings. Use RouteFinder Manager to enter your modem or TA strings.
13. The Setup Wizard: Modem Setting dialog box re-displays. Select the baudrate from the
Asynchronous port settings list. Select the DTE speed (the speed of communication between
the asynchronous port of the RF102S and the modem). For DCE speed compression modems,
this can normally be set to about four times the speed of your modem. If you set the baudrate
too high, the dial-up connection may fail.
Note: You may need to set a lower baudrate since the modem’s maximum connection speed
may not be attainable due to variations in phone line quality and ISP connection.
Click Next to complete the basic configuration.
14. The Check List dialog box displays, summarizing your configuration selections. Verify that all
selections are correct. If you find an incorrect setting, click Back to return to the window
containing the error and correct it. When finished, click Next to return to the Check List dialog
box.
Click Finish to complete the configuration.