User guide

18
Chapter 3 - Software Installation and Configuration
Record the values presented in the Device Information panel for later reference.
Device IP Address ______________________
Device Firmware Version _________________
Click Next.
Note: If a message appears indicating the device is not found, or you do not see the device
you are attempting to configure listed, click Refresh Device List.
6. The Setup Wizard: Device IP Address dialog box displays.
• Enter your local internal network’s IP address for this device.
The Setup Wizard will automatically detect the first three octets of your local IP address. You
must enter the last octet only.
• If you want, you can change the network name of your RouteFinder. If your ISP requires
your device to have a name, you may use the name entered.
• Click Next to continue. The device will search the network to ensure that the IP address is
valid. This may take several seconds.
Note: If your ISP provided you with an IP address, do not enter that address. Enter the IP
address for this device on your local network. Refer to the Glossary in this User Guide for
additional information on IP addressing.
7. The Setup Wizard: Port Function dialog box displays.
Select IP Routing (NAT Enabled) to enable local LAN clients to share one external IP
address for accessing the Internet. Select Remote Access to enable remote users to use a
dial-up connection to log on to the network. Internet.
Click Next.