User guide

SYSTEM
FW Upgrade
If new firmware is available, you can upgrade router firmware through the WEB GUI here. Press Browse to indicate
the file name of new firmware, and then press Upgrade to start to upgrade new firmware on this device. If you
want to upgrade a firmware which is from GPL policy, please check Accept unofficial firmware
Note: Do not turn off device until upgrade is complete.
System Time
■ Time Zone: Select a time zone where this device located.
■ Auto-Synchronization: Check Enable to enable this function.
■ Sync with Time Server: Click on the button if you want to set Date and Time by NTP Protocol.
■ Sync with my PC: Click on the button if you want to set Date and Time using the PC’s Date and Time.
Others
In this section you can do system backup, reset to default, system reboot settings and Ping test.
■ Backup Setting: You can backup your settings by clicking Backup and save it as a bin file. Once you want to
restore these settings, click Firmware Upgrade and use the bin file you saved.
■ Reset to Default: You can also reset this device to factory default settings by clickingReset.
■ Reboot: You can also reboot this device by clicking Reboot.
■ MAC Address for Wake-on-LAN: Wake-on-LAN (WOL) is an Ethernet networking standard that allows a
computer to be turned on or awakened by a network message.
■ Domain Name or IP address for Ping Test: This allows you to configure an IP, and ping the device.
■ Domain Name or IP address for Traceroute: Traceroute is a network diagnostic tool for displaying the route
(path) and measuring transit delays of packets across an IP network.
MultiConnect
®
rCell 500 Series Router User Guide 47