User guide

VPN SETUP
■ MPPE Encryption Mode: Check to enable MPPE encryption. The MPPE needs to work with MSCHAP(v1 or
v2) authentication.
■ Encryption Length: Choose encryption length of MPPE encryption.
■ User Account: Input up to 10 different user accounts for PPTP server.
■ Connection Status: The connected PPTP user & connection information will be shown in this table.
VPN-PPTP Client
■ VPN-PPTP Client: Enable or Disable PPTP client function.
■ User Account: Input up to 10 different user accounts for PPTP client, define each user account settings by
clicking on the corresponding Edit button, and check Enable.
■ Name: The name of this rule.
■ Peer IP/Domain: The IP address or Domain name of remote PPTP server.
■ User Name: The user name which is provided by remote PPTP server.
■ Password: The password which is provided by remote PPTP server.
■ Default Gateway: You can check Enable to set this tunnel as the default gateway for WAN connection.
■ Peer Subnet: The LAN subnet of remote PPTP server.
■ Connection Control: There are three options for users to choose when the PPTP tunnel is established.
Options are: Connect-on-Demand, Auto Reconnect (always-on), or Manual.
■ Option: Enable or disable MPPE and NAT function. If you enable MPPE, then this PPTP tunnel will be
encrypted.
■ Authentication: Enable if remote PPTP server requests it.
■ Authentication Protocol: Choose authentication protocol as PAP, CHAP, or MSCHAP(v1 or v2). The protocol
you choose must be supported by remote PPTP server.
■ LCP Echo Type: Choose the appropriate connection keep alive.
VPN-L2TP Server
The VPN gateway can behave as a L2TP server, and allows remote hosts to access LAN servers behind the L2TP
server. The device can support three authentication methods: PAP, CHAP, MSCHAP(v1 and v2). Users can also
enable MPPE encryption when using MSCHAP.
■ VPN-L2TP Server: Enable or Disable L2TP server function.
■ L2TP Over IPsec: L2TP over IPSec VPNs allow you to transport data over the Internet, while still maintaining
a high level of security to protect data. Enter a Pre-sharekey when you use some devices to establish L2TP
tunnels.
■ Server Virtual IP: The IP address of L2TP server. This IP address should be different from IP address of PPTP
server and LAN subnet of VPN gateway.
■ IP Pool Starting Address: Device will assign an IP address to remote L2TP client. This value indicates the
beginning of IP pool.
■ IP Pool Ending Address: Device will assign an IP address to remote L2TP client. This value indicates the end
of IP pool.
■ Authentication Protocol: Choose authentication protocol as PAP, CHAP, or MSCHAP(v1 or v2).
40 MultiConnect
®
rCell 500 Series Router User Guide