Manualshelf

User guide

ManualsBrandsMultitech ManualsComputer equipmentrCell 500 Series
11121314151617181920
BASIC NETWORK
WAN Type Description
PPP over Ethernet (PPPoE) Widely used for ADSL connections.
PPTP This WAN type is used primarily in Russia.
L2TP The WAN type is used primarily in Israel.
WAN
Click Edit, next to the WAN type you want view or configure.
■ Plysical Interface: Choose Ethernet, 3G/4G, or USB 3G/4G.
■ Operation Mode: WAN-1 is set to Always on. Options are Always on, Failover, or Disable for other WAN
connections.
■ Line Speed: Manually set your upload and download Mbps.
4G WAN
1. Under the Internet Setuptab, click Edit for WAN-1.
2. Check to Enable Network Monitoring. Then Save.
3. On the Physical Interface tab, click Edit for WAN-2.
4. Under Operation Mode, choose Failover for WAN-1 from the dropdown list. Then Save.
5. On the Internet Setup tab, click Edit for WAN-2.
6. Set WAN Type as 3G/4G.
7. For Preferred SIM Card, select SIM-A.
8. Under Dial-up Profile, choose either Auto-detection or Manual-configuration.
a. For Manual Configuration complete the following:
i. Select Country.
ii. Under Service Providers, choose appropriate Service Provider or Others.
iii. Manually enter in APN, PIN Code (if needed), Dial Number, Account, and Password (if
needed).
Note: If you chose a Service provider, some of the information will be automatically populated.
iv. Set Authentication to Auto.
v. Primary and Secondary DNS may be left blank. All other settings can be left at default.
vi. Click Save.
b. For Auto-detection enter PIN Code (if needed) and click Save.
9. Select Status from the menu on the left.
10. SelectNetwork status from the list.
11. Verify that WAN-2 shows under WAN Interface IPv4 Network Status.
To Verify Cellular Failover/Fallback is working, complete the following:
1. While on the Network Status page, pull the primary WAN Ethernet cable from teh E1/WAN interface.
2. Monitor WAN-2 connection status. It will go from connectingto connected.
Note: This will take approximately 45 seconds.
3. Plug back in the primary WAN Ethernet cable. The WAN-2 connection status will show disconnected.
18 MultiConnect
®
rCell 500 Series Router User Guide