User guide

7
Chapter 1 - Introduction and Description
Preview of this Guide
This guide describes the MultiVOIP and tells you how to install and configure the unit. The
information contained in each chapter is as follows:
Chapter 1 - Introduction and Description
Chapter 1 describes the MultiVOIP. Front panel indicators, and back panel connector descriptions are
provided. In addition, a list of relevant specifications is provided at the end of the chapter.
Chapter 2 - Installation
Chapter 2 provides information on unpacking and cabling your MultiVOIP. The installation procedure
describes each cable connection.
Chapter 3 - Software Loading and Configuration
Chapter 3 provides instructions for software loading and initial configuration. The MultiVOIP software
disks are Windows® based. Later chapters, as well as the online Help, describe the MultiVOIP
software in more detail.
Chapter 4 - MultiVOIP Software
Chapter 4 describes the MultiVOIP software package designed for the Windows ® environment. This
chapter describes the software from an applications standpoint, and in so doing, not every element of
the user interface is shown nor defined. For explanations and parameters, refer to the Help.
Chapter 5 - Remote Configuration and Management
Chapter 5 provides procedures for changing the configuration of a remote MultiVOIP. Remote
configuration enables you to change the configuration of a unit by simply connecting two modems
between the two MultiVOIPs and remotely controlling the unit. Chapter 5 also describes typical client
applications, such as Telnet and Web-based management, used for remote configuration of the
MultiVOIP.
Chapter 6 - Warranty, Service and Tech Support
Chapter 6 provides instructions on getting service for your MultiVOIP at the factory, a statement of
the limited warranty, information about our Internet presence and user bulletin board service, and
space for recording information about your MultiVOIP prior to calling Multi-Tech’s Technical Support.