User guide

60
Chapter 5 - Remote Configuration and Management
LAN-Based
The LAN-based remote configuration requires a Windows Sockets compliant TCP/IP stack. TCP/IP
protocol software must be installed and functional before the configuration program can be used.
1. You must assign an Internet (IP) address for the PC and for each node that will be managed
by the configuration program. Refer to the protocol software documentation for instructions
on how to set the IP addresses.
Once you have completed this step, you should be able to use the protocol Ping command
for the PC host name. You should also test the network interface configuration by Pinging
another TCP/IP device that is connected to the network.
2. Install the MultiVOIP software on the local PC. When installed click Start | Programs |
MultiVOIP 200 | Configuration Port Setup, or double-click on the Configuration Port
Setup icon in the MultiVOIP 200 program group.
3. The MultiVOIP Port Setup dialog box displays.
Verify that the IP option is selected in the Communication Type group.
In the MultiVOIP IP Address box, enter the IP Address of the remote MultiVOIP.
4. Click OK when you are satisfied with your selections.
5. Run the MultiVOIP Configuration program. Click Start | Programs | MultiVOIP 200 |
MultiVOIP Configuration, or double-click on the MultiVOIP Configuration icon in the
MultiVOIP 200 program group.