User guide

Cabling

Cabling Your MultiVOIP 200

Cabling your MultiVOIP 200 involves making the proper Power,

Command Port, and Internet connections. Figure 6 shows the

back panel connectors and the associated cable connections.

The Cabling Procedure section provides step-by-step

instructions for cabling your MultiVOIP 200.

Note: Before cabling your MultiVOIP 200, perform the E&M

Jumper Block Positioning Procedure if either voice/fax channel

(1 or 2) will be connected to an E&M trunk that is a Type 1,3, 4,

or 5 rather than a Type 2 (the default).

Cabling Procedure

1. Using the supplied cable, connect the power supply to a

live AC outlet, then plug the power supply into the

MultiVOIP 200 as shown in Figure 3. The power connector

is a 6-pin circular DIN connector.

Voice/Fax Channel

1 & 2 Connections

Network Connection

Power Connection

FXS

E&M FXO

PSTN

Command Port Connection

Hub

PBX

Voice/Fax Channel 1

E&M FXS FXO

Voice/Fax Channel 2

FXO FXS E&M

Power

Ethernet RS232

Command

10Base-T

Figure 3. Cable Connections

2. Connect the MultiVOIP 200 to a PC using the RJ-45 to

DB9 (female) cable provided with your unit. Plug the RJ-45

end of the cable into the Command port of the MultiVOIP

200 and connect the other end to the PC’s serial port

(Figure 3).