User guide

Chapter 4 – Configuring Your MultiVOIP
34 MultiVOIP® Voice/Fax over IP Gateways
Configuration Information Checklist
The following chart helps you organize the configuration information needed. The –SS and –FX models do not
support E&M or DID.
Type of Configuration Info Gathered:
Configuration window where info is entered:
Info
Obtained?

Info
Entered?

IP info for VOIP unit
 IP address
 Gateway
 DNS IP (if used)
 802.1p Prioritization (if used)
Ethernet/IP parameters
Interface Type
 E&M
 FXS/FXO*
 DID-DPO
Interface parameters
(*In FXS/FXO systems, channels used for phone, fax, or key
system are FXS; channels used for analog PBX extensions
or analog telco lines are FXO).
E&M info (only if E&M used)
 Type (1-5)
 2 or 4 wires
 Dial Tone or Wink
Interface parameters
Country code
Regional parameters
Email address for VOIP (optional)
SMTP parameters
Reminder: Be sure to Save Setup after entering configuration values.