User guide

Chapter 6 — Using the Software
Multi-Tech Systems, Inc. 99
6. Progress bars will appear at the bottom of the screen during the file transfer.
The MultiVOIP’s “Boot” LED will turn off at the end of the transfer.
7. 7. The Download Firmware procedure is complete.
Downloading Factory Defaults
1. The MultiVOIP Configuration program must be off when invoking the Download Factory Defaults command.
If it is on, the command will not work.
2. To use the Download Factory Defaults command, go to Start | Programs | MultiVOIP n.nn. | Download
Factory Defaults.
3. If a password has been established, the Password Verification screen will appear.
Type in the password and click OK.
4. The MVP n.nn - Firmware screen appears saying “MultiVOIP [model number] is up. Reboot to Download
Firmware?”
Click OK to download the factory defaults.
The “Boot” LED on the MultiVOIP will light up and remain lit during the file transfer process.
5. After the PC gets a response from the MultiVOIP, the Dialog – IP Parameters screen will appear.