User guide

Chapter 4—Configuring your VOIP
Multi-Tech Systems, Inc. 45
Field Name
Values
Description
Enable SNMP
Agent
Y/N
Enables the SNMP code in the firmware of the MultiVOIP. This must be enabled for
the MultiVOIP to communicate with and be controllable by the MultiVOIP Manager
. Default: disabled
Trap Manager Parameters
Address
n.n.n.n
MultiVOIP Manager computer IP address.
Community Name
--
A community is a group of VOIP endpoints that can communicate with each other.
Public is used to designate a grouping where all end users have access to entire
VOIP network. Calling permissions can be configured to restrict access as needed.
Port Number
162
The default port number of the SNMP manager receiving the traps is the standard
port 162.
Community Name
1
Length = 19
characters (max.)
Case sensitive.
First community grouping.
Permissions
Read-Only,
Read/Write
If this community needs to change MultiVOIP settings, select Read/Write.
Otherwise, select Read-Only to view settings.
Community Name
2
Length = 19
characters (max.)
Case sensitive.
Second community grouping
Permissions
Read-Only,
Read/Write
If this community needs to change MultiVOIP settings, select Read/Write.
Otherwise, select Read-Only to view settings.
Regional
The Regional Parameters are used to set the phone signaling tones and cadences. For the country selected, the
standard set of frequency pairs will be listed for dial tone, busy tone, ‘unobtainable’ tone (fast busy or trunk
busy), ring tone, and other, more specialized tones. If you need settings that are not available, the Custom
selection will let you set the tones to what is necessary.
Regional parameters