User guide

Chapter 3—Software Installation
Multi-Tech Systems, Inc. 17
a. Bellcore is the only option available
b. CallerID Manipulation is available if needed
4. Pass Through (opens an audio path through the MultiVOIP)
5. FXS Options
a. Set Ring Count (the number of rings allowed before call abandoned; default is 8)
b. Use Current Loss (MultiVOIP interrupts current to disconnect)
c. Generate Current Reversal (activates Answer/Disconnect Supervision to FXO)
6. FXO Options (not available for the MVP130-FXS)
a. Ring Count (set number of rings before MultiVOIP answers)
b. No Response Timer (set time to attempt call before abandoning)
c. Supervision Button (for call answering and disconnection settings)
● Answer Fields:
 Current Reversal (use current reversal to answer)
 Answer Delay
 Answer Delay Timer (in seconds)
 Tone Detection (allow tone sequence to disconnect)
 Available Tones
 Answer Tones (shows current selection from Available Tones)
● Disconnect Fields
 Current Reversal (use current reversal to disconnect)
 Current Loss (loss of current will trigger disconnect)
 Current Loss Timer (time after current loss to disconnect; in milliseconds)
 Silence Detection Enable (use silence detection to disconnect)
 Silence Detection Type (one-way or two-way)
 Silence Timer (time of silence needed to trigger disconnect; in seconds)
 DTMF Tone (use tones to disconnect)
 Disconnect Tone Sequence (select tone pairs to use for disconnecting)
 Tone Detection (disconnect from termination of tone)
 Available Tones
 Disconnect Tones (shows current selection from Available Tones)
7. DID Options (not available for the MVP130-FXS)
a. Start Modes (Immediate, Wink or Delay Dial)
b. Wink Timer (in milliseconds)