User guide

Multi-Tech Systems, Inc. 12
Introduction
Configuring software for your MultiVOIP entails three tasks:
Loading the software onto the PC (this is “Software Installation” and is discussed in this chapter).
Setting values for telephony and IP parameters that will fit your system (details are in Chapter 4).
Establishing “phonebooks” that contain the various dialing patterns for VOIP calls made to different locations (a
detailed discussion of this is found in Chapter 5).
Installing the Software
To download and install the software:
1. Go to multitech.com/setup/product.go and select your model.
2. Click the Software tab and download the MultiVOIP Manager file.
3. Double-click mvm108d8.exe to extract the files.
4. Double-click on c:\mvm108d8\Disk1\Setup.exe.
5. Click Yes to allow the program to make changes and launch the Installation Wizard.
6. Click Next and follow the wizard instructions to install your MultiVOIP software.
7. Click Finish to exit the wizard. Click Yes to launch the software.
Setup Overview
There are a few necessary settings that need to be entered in the configuration software to achieve this and
they are noted in the action lists for the categories below. The following chapters will cover all aspects in detail,
but here we will cover the basic configuration needed to start VOIP communications. Below you will find the list
of categories requiring information to be set before VOIP communication will be ready.
 Ethernet/IP
 Voice/Fax
 Interface
 Call Signaling
 Regional
 Phone Book
This setup process is followed by the Save & Reboot step which is very important.