User guide

Phonebook Starter Config.
MultiVOIP Quick Start Guide 22
Phonebook Starter Configuration (with
remote voip)
If the topic of voip phone books is new to you, it may be
helpful to read the PhoneBook Tips section (page 43)
before starting this procedure.
To do this part of the quick setup, you need to know of
another voip that you can call to conduct a test. It should
be at a remote location, typically somewhere outside of
your building. You must know the phone number and IP
address for that site. We are assuming here that the
MultiVOIP will operate in conjunction with a PBX.
You must configure both the Outbound Phonebook and
the Inbound Phonebook. A starter configuration only
means that two voip locations will be set up to begin the
system and establish voip communication.