User guide

Chapter 6: Using the Software
Multi-Tech Systems, Inc. MVPGSM 96
Call Progress Details: Field Definitions (continued)
Field Name Values Description
Supplementary Services Status
SIP Call on Hold alphanumeric Describes held call by its IP address source, location/gateway identifier,
and hold duration. Location/gateway identifiers come from Gateway
Name field in Phone Book Configuration screen of remote VOIP.
GSM Call on Hold alphanumeric Displays the phone number/SIP URL of a call that is on hold.
GSM New Call Details alphanumeric Displays the phone number/SIP URL of a newly generated call.
Call Status fields
Call Status OnHook; Call Setup;
Ringback; Active; Hangup
Shows condition of current call.
Wireless Module
Status
Not Responding;
Disabled; No SIM; Ready;
SIM PIN Required;
SIM PUK Required
This displays the current status of the wireless module on this
channel.
SIM Registration
Status
“Not registered, currently
not searching for a new
operator”;
“Registered to home
network”;
“Not registered, currently
searching for a new
operator”;
“Registration denied”;
“Unknown”;
“Registered, roaming”
This shows the registration status of the module on this
channel.
Signal Strength 0-99 0-3 is an insufficient signal for use.
4-9 is a low strength signal that is usable.
10-19 is a medium strength and is a good connection.
20-31 is a high strength and is an excellent connection.
99 means there is no signal at all.
Note section
(Options & Signal Strength Ranges)
“SC” stands for Silence Compression. With Silence Compression enabled,
the MultiVOIP GSM will not transmit voice packets when silence is
detected, thereby reducing the amount of network bandwidth that is
being used by the voice channel.
“FEC” stands for Forward Error Correction. Forward Error Correction
enables some of the voice packets that were corrupted or lost to be
recovered. FEC adds an additional 50% overhead to the total network
bandwidth consumed by the voice channel.
Reset (button) - Clicking this button will reset the channel including the wireless module.
Disconnect (button)
-
Clicking this button will disconnect the current connection on this
channel.