User guide

76
MultiVOIP 400/800 User Guide
LAN-Based
The LAN-based remote configuration requires a Windows Sockets compliant TCP/IP stack. TCP/IP
protocol software must be installed and functional before the configuration program can be used.
1. You must assign an Internet (IP) address for the PC and for each node that will be managed by
the configuration program. Refer to the protocol software documentation for instructions on how
to set the IP addresses.
Once you have completed this step, you should be able to use the protocol Ping command for
the PC host name. You should also test the network interface configuration by Pinging another
TCP/IP device that is connected to the network.
2. Install the MultiVOIP 400/800 software on the local PC. When installed, click Start | Programs |
MultiVOIP 800 | Configuration Port Setup, or double-click the Configuration Port Setup icon
in the MultiVOIP 400/800 program group.
3. The MultiVOIP Port Setup dialog box is displayed.
Verify that IP is set for the Communication Type.
In the MultiVOIP 400/800 IP Address field, enter the IP Address of the remote MultiVOIP 400/
800.
4. Click OK when you are satisfied with your selections.
5. Run the MultiVOIP 400/800 Configuration program. Click Start | Programs | MultiVOIP 800 |
MultiVOIP Configuration, or double click the MultiVOIP Configuration icon in the MultiVOIP
400/800 program group.
The Reading Setup dialog box is displayed.