User guide

47
Chapter 3 - Software Loading and Configuration
19. Enter the IP address (204.022.122.118) of the New York Office MultiVOIP 400/800 in the Master
IP Address field and enable the Send Status Report to Master so that status reports are sent
to the Master MultiVOIP 400/800.
Note: In a Dial-On-Demand (DOD) network, you should leave Send Status Report to Master
disabled (not checked). This allows the router to disconnect whenever there is no voice activity.
Note that Slaves with Send Status Report to Master disabled will show up as “Unknown” when
viewing Slave status on the Master.
20. Click OK to return to the Main menu.
21. Click Download Setup to write the new configuration to the slave unit. The Save Setup dialog
box is displayed.
22. Select (check) the Save Current Setup as User Default Configuration and click OK. The Writing
Setup dialog box is displayed as the setup configuration is written to the MultiVOIP 400/800.
After the setup is written to the MultiVOIP 400/800, it reboots.
23. Check that the Boot LED on the MultiVOIP 400/800 is off after the download is complete. This
may take several minutes as the MultiVOIP 400/800 reboots.
24. You are returned to the Main menu.
Your MultiVOIP 400/800 is operational at this time.
Repeat the process for each of the slave units. When all slaves have been configured, go to
“Deploying the Network.”