Specifications

MultiVOIP Gatekeeper Software Guide 5 Calls Window
31
Editing Destination Parameters (manual mode only)
When the call is in one of the states: Address Resolution, Setup Arrive, Wait Dest
Connect, or Call Cannot Complete, you can edit the parameters of the destination. In
this case, the Gatekeeper program does the following:
• Checks whether an IP address is supplied.
• Looks for names.
• Looks for phone numbers.
Thus if you want to enter a new name, you must first delete the existing IP address. If
you want to enter a new phone number, you must also delete the existing names.
After supplying the new destination, click the Address Resolution button.
Call Details Commands (manual mode only)
Confirm
Causes the Gatekeeper to take the default action in the current state.
Address Resolution
Causes the Gatekeeper to perform the address resolution process on the supplied
addresses. The Gatekeeper searches the Registration Table until an online endpoint
with one of these addresses is found. (When an IP address is supplied, this search is
not executed.) If this action is executed when the call is in the Wait Destination
Connect state, the Gatekeeper disconnects the destinations already found and restarts
the address resolution process.
Connect Origin
Creates a one-legged call that is terminated in the Gatekeeper when the call is in
Setup Arrive state.
Reject
Causes the Gatekeeper to disconnect the call without completing it. Reject only affects
calls that are not yet connected.
Send RIP
Opens the RIP Message dialog box for sending a Request in Progress message.
RIP Message Dialog Box
In the RIP Message dialog box, you can set a delay time for a Request In Progress
message that you want to send to the Gatekeeper of the origin or destination that sent
an ARQ, DRQ or BRQ. The purpose of the delay time is to allow time for processing
the message before sending a confirm or reject message.