User guide

60
Chapter 8 - Remote Configuration and Management
Multi-Tech Systems, Inc. MultiVOIP User Guide
LAN-Based
The LAN-based remote configuration requires a Windows Sockets compliant TCP/IP stack.
TCP/IP protocol software must be installed and functional before the configuration program
can be used.
1. You must assign an Internet (IP) address for the PC and for each node that will be
managed by the configuration program. Refer to the protocol software documentation
for instructions on how to set the IP addresses.
Once you have completed this step, you should be able to use the protocol Ping
command for the PC host name. You should also test the network interface
configuration by Pinging another TCP/IP device that is connected to the network.
2. Install the MultiVOIP software on the local PC. When installed click Start | Programs
| MultiVOIP 100 | Configuration Port Setup, or double-click on the Configuration
Port Setup icon in the MultiVOIP 100 program group.
3. The MultiVOIP Port Setup dialog box displays.
Verify that the IP option is selected in the Communication Type group.
In the MultiVOIP IP Address box, enter the IP Address of the remote MultiVOIP.
4. Click OK when you are satisfied with your selections.
5. Run the MultiVOIP Configuration program. Click Start | Programs | MultiVOIP 100 |
MultiVOIP Configuration, or double-click on the MultiVOIP Configuration icon in
the MultiVOIP 100 program group.
6. The MultiVOIP 100 Setup dialog box displays. This is the dialog box of the remote
MultiVOIP. Refer to the online Help provided with your MultiVOIP for the definition of
each dialog box.