User guide

39
Chapter 6 - Deploying the VOIP Network
Multi-Tech Systems, Inc. MultiVOIP User Guide
Connecting the Client MVP120
1. Connect one end of the power supply to a live AC outlet and connect the other end to
the Power connection on your MultiVOIP.
ETHERNET
POWER
PHONE
Power Connection
Ethernet Connection
XFO
Voice/Fax Channel
Connection
FXO
PSTN
Remote Site Cable Connection
2. Connect a network cable to the ETHERNET (RJ-45) connector on the back of your
MultiVOIP.
3. If you are connecting a PSTN or PBX/FXO port, connect one end of an RJ-11 cable
to the Phone connector on the back of the MultiVOIP and the other end to the PSTN
or PBX/FXO port.
4. Turn on power to the MultiVOIP by moving the ON/OFF switch on the right side panel
to the ON position. Wait for the Boot LED on the MultiVOIP to go off before
proceeding. This may take a couple of minutes.
5. At this time your VOIP network should be fully operational. Dial one of the sites in
your network using the dialing directory supplied by your network Administrator.